ANTI-FREEZE, ACCELERATING, 5 GALLON, NON-CHLORIDE, WATER REDUCING ADMIXTURE FOR CONCRETE AND MORTAR

FreezBan™ Liquid and FreezBan® Beads are multipurpose admixtures for use to accelerate set rates with Portland cement/lime mortar and prepared masonry mortars and nonreinforced concrete. This exclusive formulation combines an effective and time-proven chemical accelerator, calcium chloride, with a powerful wetting agent.

USES
Plain concrete and mortar placements down to 15°F (-9°C)
· Setting brick, concrete block, stone, glass block, and structural clay tile
· In areas where specifications call for noncorrosive non-chloride accelerating admixture
· Precast, post-tensioned and cast-in-place structural concrete

ADVANTAGES
· Improves workability of concrete & masonry
· Permits masonry to bear loads sooner
· Improves adhesion and mortar density
· Increases early tensile and compressive
strengths
· Significantly reduces efflorescence

DIRECTIONS
Add FreezBan NC directly to the gauging water for each batch of mortar. Under no circumstances should FreezBan NC be added to the cement or mortar.
To obtain maximum results:
· Use a windbreak around mortar board and mixer to minimize the chill factor
· Keep sand and gauging water ice free
· Protect work from freezing for first 48 hours
· Keep walls dry next to metal door or window frames. Frames may corrode due to moisture and air
· If frames are scratched or abraded apply a metal primer
· Test compatibility of the prepared mortars before use